What are the Methods for Peeling Enameled Copper Wire?

As an Enameled Copper Wire Manufacturer, share with you.

Peeling method

For thick enameled wires, use a knife or a broken saw blade to scrape off the enameled leather one by one. When scraping, do not only scrape two sides, but carefully scrape around the circle without scratching the wire. This method is called scraping and removing paint.

For thinner enameled wires, the wire will be scraped off by scraping and removing the paint. You can use the fire to remove the paint. During operation, erect the rotor assembly and straighten the end of the wire. After the length is correct, clamp the wire with pliers. No need Then use an alcohol lamp (can also be used for candles) to burn the wire on the peeled part, burn off the patent leather, and wipe it off with a gauze cloth after cooling. This method has high efficiency in removing paint, but it is easy to burn and break the wire if the operation is not mastered.

For enameled copper wires with temperature resistance levels of 130 (B), 155 (F), and 180 (H), special paint remover for enameled wire can be used for peeling. This method has fast peeling speed, no corrosion to copper wire, and low odor.

Enameled Copper Wire

Enameled Copper Wire

Multi-thread

Because the enameled wire production machines are single-end pay-off and single-end take-up, there is no multi-end.

In fact, most of the "multi-threads" are produced by users-electronics factories. During the laying-out process, the machine should be stopped every few minutes to replace the transformer skeleton. When the machine is stopped, the pay-off tension of some machines is not in place. Due to inertia, the upper coil collapses and presses the lower thread. When the machine is turned on again, the thread is pressed and the thread breaks. Formed the initial chaotic line.

After the thread breaks, it cannot be used normally, and the spool must be removed from the winding machine. Of course, you can continue to use the processed one. However, in the process of handling the messy thread, if one thread is accidentally broken, it becomes three ends, and two threads are broken, it becomes five ends. As a result, the axis can no longer be processed, and it is returned to the warehouse from the manufacturing process, and the warehouse is returned to the production plant in the name of multiple threads. This is the process of "multi-thread" production and return. In fact, multiple thread ends are easy to handle: use a sharp blade to pick and break a few turns of the thread, grab the broken thread and pull it up. Until a head appears.

Our company also has Enameled Copper Wire on sale, welcome to contact us.